A roll of IP65 waterproof 12-volt horticultural strip in a 3:1 ratio of blue and red LEDs. The photoreceptors in plants only perceive certain specific colours in the sun's light spectrum.
The colours orange and yellow are only partially assimilated as red by plants.
The same is true of violet and indigo - these two other colours are only very slightly absorbed as residual blue.
And plants are virtually insensitive to green light because they have no photoreceptor called cryptochrome for this colour.
Horticultural LED strips are built with two types of monochromeLED: 15 blue LEDs (460nm) for growth and 45 red LEDs (630nm) for flowering. They generate a very precise spectrum and their complementary nature will ensure abundant cultivation!
The light spectrum of LED strips is almost 98% absorbed by plants, which means that in an optimal growing configuration, very good yield results will be obtained.
It's easyto cut and connect your LED strip! Just use a pair of scissors to cut the strips every 3 LEDs, i.e. every 5 cm.
They are protected by an IP65 siliconeseal with 3M double-sided adhesive on the front.
The LED Strip is sold on its own , which means you can choose your power supply, lighting management system and any other elements you need to install your LED ribbon. These are available in the LED Strip accessories section and in part at the bottom of the product sheet.
Product description :
Number of LEDs: 60 LEDs per metre type 5050 RGB (15 blue 45 red)
Supply voltage: 12 volts DC
Brightness: 417.9 Lux at 1 metre
Colour rendering index: 11.9 Ra (CRI)
Power factor: >0.9
Service life: > 50,000 hours
Power consumption: 14 watts/metre (70 watts for 5 metres)
Ribbon dimensions: Length 5 metres, Width 10 mm, Thickness 3mm
Circuit board: 2 tracks
Pin spacing: 5 mm
Waterproof protection: IP65 standard
Safety assurance: CE & ROHS
Weight: 120 g per metre
Our products are guaranteed for one year.
Precautions for use :
It is advisable not to look at the light for long periods, even with protective glasses.
