Welcome to the world of retro lighting revisited with our Lynch brass socket in E27 format,this classic lamp socket evokes a time when craftsmanship was king, when every detail reflected timeless quality.
Made from the noble material of brass, this lampholder captures the essence of the past while blending harmoniously into contemporary interiors. Now also available in an elegant satin finish.
Now available in a satin finish, our Lynch brass lampholder gives you even more ways to personalise your lighting. Don't forget to select the finish of your choice from the drop-down list for the perfect match to your style.
Also discover our Lynch lampholder in a distressed finish, with a complementary shade available here on this link
Features:
E27 lamp holder
M10 thread porcelain base with two-core terminal block, phase and neutral
Material: brass with natural or satin machined finish, to choose from a range of finishes
Body diameter 40 mm
Height 57 mm without cable clamp
Shade passage diameter: 40mm
Cable connection by screws
Power rating: 2A - 250V
Maximum power of bulbs: 150 Watts
Weight: 150g
Lampholder sold individually without cable and without cable clamp
Electrical safety information.
In terms of electrical connectivity, this porcelain lampholder will be installed with wiring including phase and neutral, earthing is possible, a small hole is available on the side of the jumper to connect a small earth cable on a round lug, some pre-wired earth cables are available at the bottom of the product data sheet.
For obvious aesthetic reasons, it is difficult to envisage using a large 230 volt 2P + earth plug or socket for a floor-mounted lamp. More commonly, a flat 2-pin plug is used, allowing only phase and neutral to be connected using a two-conductor cable.
This connection without earthing is possible, but it is essential to use an anti-pull-out system for the cable coming out of the lamp. Various cable locking devices can be installed, either in the base of the lamp or directly in the bottom of the lampholder.
These small plastic mechanisms have an anti-rotation and anti-pull function for your power supply cable.
These cable locks are available in the 'You'll like them too' section at the bottom of the product sheet.
