Discover the Arvers brass lampholder cover, the elegant complement to highlight your luminaires. Its sleek exterior offers an aesthetic touch, while its interior can accommodate an E12 or E14 plastic lampholder.
Customise your installation by adding optional cable ties and other complementary accessories, available at the bottom of the product data sheet. The lampholder cover is sold on its own without the lampholder, allowing you to create your own configuration to suit your needs.
As the E12 plastic lampholder is shorter than the E14 lampholder, you will need to add a small extension sleeve, available at the bottom of the product data sheet .
Product description :
Outside diameter: 33mm
Inner diameter: 27.5mm
Height: 60mm
Weight: 17gr
For M10 tube
Composition: solid brass
Sold individually without socket and cable clamp
Electrical safety information.
In terms of electrical connectivity, this lampholder offers the versatility of being installed with wiring including phase, neutral and earth, allowing the lampholder to be installed, for example, on the ceiling.
However, for obvious aesthetic reasons, it is difficult to envisage using a large 230 volt 2P + earth plug or socket forfloor-mounted lamp installations. More commonly, a flat 2-pin plug is used, allowing only phase and neutral to be connected using a two-conductor cable.
This connection without earthing is possible, but it is essential to use an anti-pull-out system for the cable coming out of the lamp.
Various cable locking devices can be installed, either in the base of the lamp or directly in the bottom of the lampholder.
These small plastic mechanisms have an anti-rotation and anti-pull function for your power supply cable. These cable locks are available in the 'You'll like them too' section at the bottom of the product sheet.
