4 mm wide 12 volt COB LED strip for harmonious lighting without dazzling dots, this flexible 5 metre self-adhesive strip. It is equipped with 480 LEDs per metre, in white, light warm white or warm white depending on the colour.
This LED ribbon can be cut every 2.5 cm, and is coated with a translucent resin making it waterproof to IP65 standard for indoor use, but also for outdoor use, provided the ribbon is protected from splashing water.
A multitude of possible uses: It can be installed as the main source of lighting for comfortable, glare-free illumination, or indirectly, as a coving around the edge of your ceiling or at the edge of a suspended island in the centre of the room. You'll also be able to decorate and create an atmosphere in your shop windows, highlighting shelves, under a bar counter, on your terrace, banisters and stair treads etc...
You can easilycut and connect your LED strip! Just use a pair of scissors to cut the strip every 2.5 centimetres.
The LED Strip is sold on its own , so you can choose your power supply, lighting management system and any other elements you need to install your LED ribbon, which are available in the LED Strip accessories section and in part at the bottom of the product data sheet.
Product description:
Strip LED COB
Number of LEDs: 480 LEDs / metre
Light output: 500 lumens per metre, i.e. a total of 2500 lumens for 5 metres
Light colour: white 5800 Kelvin, light warm white 4000 Kelvin, warm white 3000 Kelvin
Diffusion angle: over 120
Service life: 25,000 hours
Power consumption: 5 watts/metre
Ribbon dimensions: length 5 metres, width 4 mm, thickness 2.7 mm
Colour rendering index: 90 ra
Circuit board: 2 tracks
Pin spacing: 3 mm
Supply voltage: 12 volts DC
Waterproof protection: IP65 standard
Safety assurance: CE & ROHS
Our products come with a one-year guarantee.
This product can be used with dimmers, but only with models available in the LED Strip accessories category.
To cut the LED strip, please follow the small marks at the top or remove the sticker from the back in the middle of the electrical tracks. Cutting outside these marks may damage the LED strip.
